Problem | Cause | Correction |
---|---|---|
Erratic work sizes | Gins not adjusted properly on upper and lower slides | Readjust gibs |
Wear in in-feed screw and nut | Repair infeed mechanism | |
In-feed lever not held tight | Tighten nut | |
Insufficient lubrication on slides | Provide proper lubrication | |
Work blade loose | Tighten blade | |
Parts too hot (due to wheel and/or coolant) | Change wheel, adjust coolant flow, or make wheel cut more freely | |
Feed wheel camming | Tighten collet screws, replace feed wheel bearings |