| Hardening of saw teeth |
Too heavy a cut |
Reduce cut rate on final pass |
| Wheel too hard |
Use softer/coarser wheel |
| Wheel face loaded |
Reduce wheel face |
| Wheel speed too high |
Reduce wheel speed |
| Loaded wheel |
Wheel too hard |
Use softer wheel or decrease wheel speed |
| Dirty saw before grinding |
Clean saw of wood resin before grinding |
| Uneven wheel wear |
Worn spindle bearings |
Check and replace bad bearings |
| Unequal stock removal |
Reset machine |
| Wheel too soft |
Use harder wheel or increase wheel speed of wheel RPMs allow |
